IDEC High Performance Series - Manual (Page 544)

2 Character Input
10-32 WindO/I-NV2 User’s Manual
■ Display Character with “*” *2
Select this check box to display the entered characters as * (asterisks).
If this check box is selected, nothing is displayed until a value is entered from the key buttons or keypad when the
Character Input is in entry mode. If ENT is pressed with nothing displayed, 0 is written to the destination device.
■ Change Font with Device *2
Select this check box to change the font used to display the text with a value of device.
The keypad (popup screen) can also be changed when Standard or Popup is selected for Type under Keypad on
the General tab.
*2 Advanced mode only
Trigger Device: Specifies the word device (2 words) to use as the condition to change the font.
Click to display the Device Address Settings dialog box. For the device address
configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Example: With Trigger Device set to D 100, to enter Central European text from popup screen
100 using a Character Input for entering European text from the standard keypad
(popup screen 3003)
Write 6 to D 100 and 100 to D 101.
Font number Popup screen No.
1st word 3rd word 2nd word Font number
1. Japanese
2. European
6. Central European
7. Baltic
8. Cyrillic
Popup screen No. 1 to 3015