Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 177)

Getting Started Manual
922157-00 Rev A 169
The Select Measurement pop-up.
Access the corresponding Px dialog to change other setup items as follows:
1. Touch inside the Source1 control and select an input waveform from
the Select Source window.
2. Touch inside the Measure field and select a parameter from the
Select Measurement window.
3. Touch the Histogram button at the bottom of the dialog. After
touching this button, the Math selection for Histogram pop-up is
shown. Select the desired Math Trace in which to store the results.
Touch the Close button when you are finished.