Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 210)

LabMaster 9 Zi-A
202 922157-00 Rev A
Saving and Recalling Setups
The Save/Recall Setup dialogs allow for quick saving and recalling of up to
six oscilloscope panel settings internally on your instrument. If desired, you
can also save and recall your oscilloscope panel settings as an .lss file to a
specific hard disk location, a network location, or USB drive.
Saving Oscilloscope Setup(s)
Access the Save Setup... dialog by either selecting File → Save Setup...
from the menu bar or clicking the Save Instrument Setup button on the
main Save/Recall dialog. Now use one of the following two methods to
save setup(s).
S
AVING
S
ETUP
(
S
) I
NTERNALLY ON
Y
OUR
I
NSTRUMENT
Save your settings internally on your instrument by touching inside one of
the six SetupX data entry controls on the Save to Internal Setup... part of
the screen and providing a name. Now, touch its corresponding Save
button directly to the left. Your setup file is then saved to the D:\Internal
Setups location on your instrument and the current date/time is shown
above the SetupX data entry control.
S AVING S ETUP ( S ) D IRECTLY TO A F ILE
Save your setup(s) directly to a file by touching the File button on the Save
To section on the dialog. Now, touch inside the Save files in directory
control and provide a path to the destination folder. Or touch Browse to
navigate to the destination folder. Finally, touch the Save Now button.
Recalling Oscilloscope Setup(s)
Access the Recall Setup... dialog by either selecting File → Recall Setup...
from the menu bar or clicking the Recall Instrument Setup button on the
main Save/Recall dialog. Now use one of the following two methods to
save setup(s).
R ECALLING S ETUP ( S ) I NTERNALLY ON Y OUR I NSTRUMENT
Recall your settings located internally on your instrument by touching
inside one of the six Recall buttons on the Recall From Internal Setup...
part of the screen.
Each Recall button is labeled with a corresponding setup storage slot. If a
setup is stored, SetupX is shown along with the date/time of the save,
otherwise, the slot is labeled Empty.