Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 254)

238
CATC M ERLIN ’ S W AND 2.00 C HAPTER C
User’s Manual Merlin’s Wand Scripting Commands
Return value
• “Success”
• “Failure”
Comments
This command is used to request specified configuration for L2CAP chan-
nel. It should be executed before L2CAPConnectRequest().
For a detailed description of parameters, see the L2CAP section of the
Bluetooth Specification.
Example
L2CAPConfigurationSetup(0xFFFF, 1, 0, 0, 0, 0xFFFFFFFF,
0xFFFFFFFF);
PeakBandwidth A value that
limits the
speed at which
packets may
be sent con-
secutively
0x00000000 The default value indicates that the maximum
bandwidth is unknown.
The speed is in bytes per second.
Latency The maxi-
mum delay
that is accept-
able between
transmission
of a bit and its
initial trans-
mission over
the air
0xFFFFFFFF The default value represents a Do Not Care.
The delay is in milliseconds.
DelayVariation This value
represents the
difference
between the
maximum and
minimum
delay possible
that a packet
will experi-
ence
0xFFFFFFFF The default value represents a Do Not Care.
The difference is in microseconds.
Parameter Meaning Default Value Comments