Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 35)

19
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
•
Apply authentication and encryption.
The default authentication and encryption settings will be used.
•
Use current authentication/encryption settings.
The authentication and encryption settings that are currently set in the
Local Device manager will be used.
•
Display the Local Device Manager so I can configure security and
verify PIN codes myself.
This option allows you to access the Local Device Manager to
manually enter the security settings. If you choose this option, press
Next to open the Local Device Manager. When you close the dialog,
6 will be performed automatically.
Step 6 Press Next.
Merlin’s Wand will query the selected device to determine its profile.
When the query is complete, the Select Profile screen opens and displays
a list of profiles found.
You can now refer to the section that describes the setup for the particular
profile that the target device uses:
•
Section , “Connect to Device: Dial-Up Gateway” on page 19
•
Section , “Connect to Device: Fax Gateway” on page 21
•
Section , “Connect to Device: File Transfer” on page 22
•
Section , “Connect to Device: HCRP Server” on page 23
•
Section , “Connect to Device: Headset” on page 24
•
Section , “Connect to Device: Headset Audio Gateway” on page 25
•
Section , “Connect to Device: LAN” on page 26
•
Section , “Connect to Device: Object Push” on page 26
•
Section , “Connect to Device: PAN–GN” on page 27
•
Section , “Connect to Device: PAN–NAP” on page 28
•
Section , “Connect to Device: Serial Port” on page 29
Connect to Device: Dial-Up Gateway
Follow these steps to configure Merlin’s Wand to connect to a Bluetooth
device that uses the Dial-Up Gateway profile.
Note To connect to a device that uses the Dial-Up Gateway profile, you must install the
virtual COM port driver that is included with the Merlin’s Wand installation. For
instructions, see “Installing the Virtual COM Port Driver” on page 39.
Step 1
Complete steps 1-6 in Section 3.2, “Connecting to Devices”
on page 17.
Step 2 Select Dial-up Gateway from the list on the Select Profile