Vanguard TRM-203_403 User Manual
Page 55
REV 1 TRM-203 AND TRM-403 USER’S MANUAL
51
3.12 Performing a Special Resistance Test
The Special Resistance Test is used to conduct a resistance test for a pre-defined period ranging
from 1 to 90 minutes. The resistance data is recorded either at 30 second or 60 second
intervals. Use the steps below to perform a Special Resistance Test:
a. Start from the “START-UP” ” menu:
Press the
[1]
key (RUN TEST).
b. The following screen will be displayed:
Press the
[2]
key (SPECIAL RES TEST).
c. The following screen will be displayed:
Select the phase to test by pressing the corresponding numeric key on the keypad. For
this example, we will be testing phase H/X1-H/X0, so press the
[1]
key.
SELECT PHASE:
1.
H/X1-H/X0 (YN PH A)
2.
H/X2-H/X0 (YN PH B)
3.
H/X3-H/X0 (YN PH C)
4.
H/X1-H/X3 (Δ PH A)
5.
H/X2-H/X1 (Δ PH B)
6.
H/X3-H/X2 (Δ PH C)
1.
RESISTANCE TEST
2.
SPECIAL RES TEST
3.
DYNAMIC LTC TEST
4.
DEGAUSS WINDING
1.
RUN TEST
2.
SETUP
3.
USER DIAGNOSTICS
07/31/12
13:12:11
22
°C 72°F