Vanguard TRM-203_403 - Manual (Page 71)

REV 1 TRM-203 AND TRM-403 USER’S MANUAL
67
3.16 Working with Test Records
3.16.1. Saving Test Records
After performing a test, the user is presented the option to save the test results to the unit’s
Flash EEPROM or to a connected USB Flash Drive. If the test results are not saved immediately
after performing a test, they will still remain in the working memory and can be saved later, as
long as a new test has not been performed and the unit has not been turned off. Follow the
steps below to save the test results from the working memory to a test record (the following
procedure can also be used to re-save a restored test record to a new memory location or to a
USB Flash Drive):
a. Start from the “START-UP” menu:
Press the [2] key (SETUP).
b. The following screen will be displayed:
Press the [3] key (SAVE/RESTORE RECORD).
c. The following screen will be displayed:
NOTE
Option 5 (COPY TO THUMB DRIVE) will be listed only if a USB Flash drive is
connected to the DigiTMR S2.
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
5. COPY TO THUMB DRIVE
1. RECORD ID
2. PRINT RECORD
3. SAVE/RESTORE RECORD
4. SET TIME
5. SET LANGUAGE
1. RUN TEST
2. SETUP
3. USER DIAGNOSTICS
07/26/12
13:45:35
22 °C 72°F