Yokogawa In-Situ Gas Analyzer TDLS200 - Manual (Page 142)

10-7
IM 11Y01B01-01E-A 6th Edition :Feb 13, 2013-00
<10. Data Files anD Format>
10.2 Downloading (Transferring/Exporting) the Data:
All the files can be easily transferred from the analyzer to the supplied USB memory device.
NOTES: Please use the supplied “Sandisk” USB memory device with when getting data from the analyzer.
Each analyzer is supplied with one pre-tested USB memory devices -please retain them and use with each
appropriate analyzer.
If an un-recognized USB memory device is used, then the MS Windows XPe operating system may attempt to
install new hardware. This will not affect the normal operation of the analyzer however, if you have a full display
interface operational a Windows based pop-up may ask for a system reboot.
Do not attempt to plug in any other USB based products (keyboards, WiFi, etc.) in to the USB ports
– Windows based hardware conflicts may occur.
Simply insert the memory device and wait for the Data Transfer to complete. Do not remove the device before
the transfer is complete. The analyzer will advise via the user interface when Data Transfer is complete. For
totally blind units (i.e. no user interface) wait for the indicating LED to stop blinking/flashing for at least 5 minutes
to ensure the transfer is complete.
TDLS200 TDL Analyzer Instruction Manual V2.1
Page 128 of 131 - 128 -
7.2 Downloading (Transferring/Exporting) the Data:
All the files can be easily transferred from the analyzer to the supplied USB memory device.
NOTES: Please use the supplied “Sandisk” USB memory device with when getting data
from the analyzer. Each analyzer is supplied with one pre-tested USB memory devices –
please retain them and use with each appropriate analyzer.
If an un-recognized USB memory device is used, then the MS Windows XPe operating system
may attempt to install new hardware. This will not affect the normal operation of the analyzer
however, if you have a full display interface operational a Windows based pop-up may ask for a
system reboot.
Do not attempt to plug in any other USB based products (keyboards, WiFi, etc.) in to the USB ports
– Windows based hardware conflicts may occur.
Simply insert the memory device and wait for the Data Transfer to complete. Do not remove the
device before the transfer is complete. The analyzer will advise via the user interface when Data
Transfer is complete. For totally blind units (i.e. no user interface) wait for the indicating LED to
stop blinking/flashing for at least 5 minutes to ensure the transfer is complete.
Insert Yokogawa
Supplied USB
memory Storage
Device