Yokogawa In-Situ Gas Analyzer TDLS200 - Manual (Page 94)

6-37 6-38
IM 11Y01B01-01E-A 6th Edition :Feb 13, 2013-00
<6. BASIC OPERATION>
6.9.5 OPTIONAL Virtual Analyzer Controller (VAC) Operating Software Guide
ALWAYS “END VNC SESSION” TO ANALYZER WHEN DONE – THIS WILL PREVENT THE ANALYZER AND/
OR RIU fROM ‘HANGING’. DO NOT LEAVE THE RIU PERMANENTLY CONNECTED TO ANALYZER –
CONNECT ONLY WHEN IN USE
6.9.6 Virtual Analyzer Controller (VAC) Operating Software Guide
The RIU VAC software is designed to allow communication
between an analyzer and an appropriate interface.
The primary functions of the software are:
Create a virtual network computing connection to an analyzer thus
allowing for control of the analyzer, typically for start-up, service,
calibration, etc.
Allow for file transfer from an analyzer to a local USB port (for
memory device)
Create connections by name and/or IP address
After selecting “Connect F2” you will be allowed to select the
analyzer (with description and IP address) you wish to control
remotely.
This will allow full analyzer control as if you were at the analyzer
itself.
Please remember that when you have finished working on the
analyzer via this RIU VAC software, you must END SESSION
to the analyzer by pressing the Control+Backspace keys
simultaneously – DO NOT SHUT DOWN analyzer!!!
After selecting “Copy Data – F3” you will be allowed to select the
analyzer (with description and IP address) you wish receive data
from.
This will initiate a data transfer for all results and configuration files
stored on the analyzer.
NOTE:
Please ensure there is a ‘clean’ (or empty) SanDisk USB memory
stick inserted into either of the two USB ports of the RIU.
When copying data from an analyzer via the RIU, a dedicated
folder with the serial number is NOT created, the data files are
dumped to the root directory of the USB stick.