Yokogawa GC1000 Mark II Process Gas Chromatograph - Manual (Page 7)

vi
<Toc> <Ind> <Rev> <Introduction>
IM 11B03A03-01E 3rd Edition : Aug. 23. 2006-00
● General Precautions
WARNING
(1) In order to analyze gases, process gas chromatographs use a sample of the process
gas and utility gases.
Since these gases are typically combustible, combustion-sustaining, toxic,
odorous, resolvable, polymerizing, or corrosive, refer to the “Safety Informa-
tion” in our approval drawings and others to ensure safety thoroughly before
using these analyzers.
(2) Up to two protection systems, each of which weighs approximately 10 kg, are installed
on top of the GC1000. Therefore, the center of gravity is higher than the center of the
analyzer body.
Take great care when carrying and installing (piping- wiring) the GC1000. The
GC1000 must be carried and installed very carefully (including piping and
wiring) by more than one person (at least four people are recommended).
(3) Since the GC1000 are precision instruments, take care when handling not to jolt
of knock them.
(4) Use the GC1000 within the range of your purchase specifications.
Yokogawa assumes no responsibility for problems resulting from use by the customer
outside the purchase specifications.
If the GC1000 need to be modified or repaired, please contact your nearest Yokogawa
representative. Yokogawa assumes no responsibility for results where the customer or
any third party has attempted to modify or repair these products.
(5) When touching LCD Panel switches
When touching LCD Panel switches, first, discharge Electro Static Charge of the body.
Then, touch the LCD Panel switches. If not, LCD display may be changed by Electro
Static Discharge.
IMPORTANT:
(1) Read the attached instruction manual before operating the GC1000
(2) The instruments must be installed and operated according to the installation manual,
instruction manual, approval drawings, and operation data.