Yokogawa Button Operated MV2000 - Manual (Page 100)

4-27
Commands
M-4662
1
2
3
4
5
6
7
App
Index
EM Starts/stops the e-mail
transmission function
Syntax EM p1<terminator>
p1
Operation type
0 Start
1 Stop
Example Start the e-mail transmission function.
EM0
Description To use the e-mail transmission function,
you must set the Ethernet interface, e-mail
addresses, and contents to be transmitted.
CU Manually recovers Modbus
Syntax CU p1<terminator>
p1
Communication type
0 Modbus client (Ethernet)
1 Modbus master (serial)
BV Enters characters
Syntax BV p1,p2<terminator>
p1
0
p2 Character string (up to 100 characters)
Example Enter user123.
BV0,user123
KE Key operation command
Syntax KE p1<terminator>
p1
Key type
F1–F7 Soft keys 1 to 7
ESC ESC key
MENU MENU key
FUNC FUNC key
START START/STOP key
HISTORY HISTORY key
USER USER key
T/DIV T/DIV key
0–9 Number 0 to 9 keys
MINUS Number minus key
DOT Number decimal key
DISP DISP/ENTER key
UP Up arrow key
DOWN Down arrow key
RIGHT Right arrow key
LEFT Left arrow key
Example Press the DISP/ENTER key.
KEDISP
Description Operates in the same way as the keys on the
MV. For a key sequence, transmit the commands
in the same order that you would press the keys
on the MV.
YC Clears measured/computed data
and initializes setup data
Syntax YC p1<terminator>
p1
Type of data to be cleared
0 Clear measured/computed data
and initialize setup data
2 Clear measured/computed data
IR Resets the relative timer
Syntax IR p1<terminator>
p1
Timer number to be reset
0 All timers
1–4 Timer number 1 to 4
MA Resets a match timer
Syntax MA p1
P1
Match timer number to be reset (1 to 4)
Example Reset match timer number 3.
MA3
Description • An error will occur if the timer operation of the
match timer is set to repeat.
• Nothing will occur if the single match timer has
not expired.
NR Sets the trend update rate
Syntax NR p1,p2<terminator>
p1
1
p2 Trend update rate [/div] (15S, 30S, 1MIN,
2MIN, 5MIN, 10MIN, 15MIN, 20MIN, 30MIN,
1H, 2H, 4H, 10H)
Query NR[ p1[,p2]]?
Example Set the trend update rate to 5 min/division.
NR1,5MIN
Description • You cannot set the trend update rate if the
memory data type is event + display.
• The logging number is fixed to 1.
• Set the data update rate and auto save rate
first with the SW command and then set the
trend update rate with the NR command.
4.5 Setting Commands (Control)