KANOMAX 3900 Portable Particle Counter - Manual (Page 34)

3. Display Description and Operation Procedure 27
3.6.3 STANDARD
- When not using MAP (Refer to 3.7 CONFIG for using a MAP.)
Tap [START] to display “CONFIRM” window.
A measurement will start based on the setting
configured in 3.5 MODE and 3.7 CONFIG.
Tap [START] to start a measurement.
z If “START DELAY” is NOT checked in
“CONFIG” setting:
Upon tapping [START], the pump will begin
running. After the pump has run for 10 seconds to
stabilize, the measurement will begin.
z If only “START DELAY” is checked in
“CONFIG” setting:
Upon tapping [START], the Delay Time
configured begins. During the last 10 seconds of
that Delay Time the pump will run to stabilize,
after which the measurement will begin.
z If “START DELAY” are checked in
“CONFIG” setting:
Upon tapping [START], “Input START TIME”
dialog box will be displayed. Enter the time when
you want to start measuring and tap [OK]. During
the last 10 seconds of the [Time left] time the
pump will start running to stabilize, after which
the measurement will begin.
Tap [CANCEL] to go back to the menu screen.
If you fail to tap [OK] after entering “START
TIME”, 10 minutes will be added to the “START
TIME” automatically when the entered START
TIME comes and will continue to wait to be
activated by pressing [OK].
<Input START TIME dialog box>
<CONFIRM window>