KANOMAX 3900 Portable Particle Counter - Manual (Page 69)

3. Display Description and Operation Procedure 62
3.10.4 HARDWARE
In HARDWARE setting, you can configure the
following settings;
- OPTION SENSOR
- PUMP
- REMOTE MODE
· OPTION SENSOR SETTING
In the OPTION SENSOR SETTING window you
can confirm if the option sensor is connected or not,
and set to use or not to use the sensor. You can also
set the unit and MIN/MAX range value for each
sensor. MIN/MAX value should be the spec range
for each sensor.
When the sensor is connected, it is displayed in blue
and if not, it is displayed in gray.
To use the option sensor, check USE/NO USE box.
After [OK] button is tapped, defined value is saved
to close window (Authentication required).
Tap [CANCEL] to discord entries.
UNIT:
Set the unit for TEMPERATURE and VELOCITY.
For TEMEPRATURE, select °C or °F
For VELOCITY, select m/sec or FPM.
MIN/MAX:
Set the measurable range of the sensor connected according to the spec of the each option sensor.
Tap the entry field to display a numeric keyboard. Enter a value and tap [Enter].
INSTANT/ AVERAGE:
Select INSTANT or AVERAGE for measurement value display format.
CHECK button:
Tap [CHECK] to confirm if the option sensor is connected or not.