KANOMAX 3900 Portable Particle Counter - Manual (Page 45)

3. Display Description and Operation Procedure 38
3.6.6 In Case that Measurement is Interrupted
If you stop a measurement in STATS or STANDARD mode before all measurements complete but there are more
than one location where a measurement is finished, the instrument will be in a temporary state of suspension.
The instrument will remain in a temporary state of suspension until a measurement restarts or completes. During this
period you cannot change a measurement mode or CONFIG setting.
[STATS]
If you start a measurement when the instrument is in a temporary state of suspension, the message below will be
displayed.
Tap [YES] to resume measuring from the next LOCATION.
If you tap [NO], you will get a message asking if you want to
save data or not.
Tap [CANCEL] to go back to the main screen.
If you tap [NO] on the window above, a
confirmation window will be displayed asking if
you want to save data or no.
Tap [YES] to save data.
Tap [NO] to discard data.
If you try to switch the mode, the below message will be displayed.
Tap [OK].
You cannot change the mode when a measurement is in a
temporary state of suspension.
Tap [START] to determine the next stop.