KANOMAX 3900 Portable Particle Counter - Manual (Page 51)

3. Display Description and Operation Procedure 44
3.7.5 STATS
If there are any MAP files saved, select the FILE to load it
in SCHEDULE.
Tap the entry field for “SAMPLE T”. to display a
numeric keypad. Enter “hour”, “minute” and “second” on
the numeric keypad and tap [OK].
Tap the entry field of “CYCLES” to display a numeric
keypad. Enter a value and tap [ENTER].
Once a MAP file is loaded, you cannot change the
settings for SAMPLE POINT. (The configured number of
measurement points in the MAP file will be applied.)
When a MAP file is not loaded, tap an entry field of
“SAMPLE POINT” to display a numeric keypad. Enter a
value and tap [ENTER].
Tap “PRESET” to display a window asking you to input
“PRESET NAME”.
Tap the entry field to display the keypad. Enter the file
name and tap [Enter].
Tap [OK] to save the current settings on the CF card
(Authentication required).
* In the future you can automatically load the configuration
saved here as a PRESET. Refer to 3.9 PRESET.
Check “AUTO SAVE” to store data automatically.
Check “AUTO PRINT” to print data automatically.
Check “START DELAY” to use delay time prior to
a measurement.
Check “Set time” to set the time when you want to
start a measurement.
Tap [OK] to save and activate the settings
(Authentication required).
<MEASURE SETTING>
<Input PRESET NAME>