ADTRAN ATLAS 810 Plus - Manual (Page 106)

Chapter 9. Dial Plan Terminal Menu
9-12 ATLAS 810 PLUS User Manual 61200266L1-1
»» Outgoing Caller ID Write Security: 3 Read Security: 5
Inserts a called ID based on the following selections:
Send as provided ATLAS forwards whatever ID it receives (including None).
Substitute if not
present ATLAS inserts a User-defined ID value if no value is received.
ID Presentation Sends to the Network control information for the presentation of Caller ID
(Presentation Allowed; Presentation Restricted; Number Not Available).
ID Number Value for Caller ID to be sent to the Network (i.e., 256 963 8020).
Substitute always ATLAS always inserts the User-defined ID in place of the value received.
ID Presentation Same as above.
ID Number Same as above.
»» Source ID Simplifies the creation of a Dial Plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
• Default value = 0. The default ID for all endpoints is 0 and for all accept
# s is 0. With default values, all calls are routed based only on dialed
number.
• Multiple endpoints can have the same Source ID .
• When creating the Call Accept list, specify a Source ID (s) as well as a
dialed number or range of dialed numbers to accept.
Say, for example, an application requires that all calls originating from
Port 1 of the Quad T1/PRI module in Slot 1 be switched to Port 4 of that
same module. Assign a unique
Source ID (e.g., 7) to Port 1 of the module,
and then configure Port 4 to only accept calls from that unique Source ID
(7).
»» Swap ANI/DNIS Swaps the ANI and DNIS numbers received from the Network. ANI (Auto-
matic Number Identification) is the billing number of the calling party, and
DNIS (Dialed Number Identification Service) is the called party number.
Quad T1/PRI Module (Network Termination/NFAS)
When you are working in the Network Termination section of the Dial Plan
menu, Slot is defined as a T1/PRI module, and Sig is set to NFAS, the fol-
This swap causes the ATLAS switchboard to use ANI to route the
call. The accept number in the Dial Plan must use the ANI number,
not the DNIS number.