ADTRAN ATLAS 810 Plus - Manual (Page 92)

Chapter 8. Dedicated Maps Terminal Menu
8-8 ATLAS 810 PLUS User Manual 61200266L1-1
Figure 8-4. Slot 0 Module Configuration Menu
Defining the Connections for Example 2
Begin by navigating to Dedicated Maps/Create/Edit Maps and naming
your map. Navigate to Dedicated Maps/Connects . The Connects sub-
menu defines the connections necessary to route the required bandwidth.
Refer to Table 8-1 on page 8-7 to define each of the necessary connections.
For this procedure, first define the data connections, and then define the
voice connections. The following Step/Action tables guide you through this
process. (Figure 8-5 shows the completed map.)
Instructions for Defining Data Connections
Step Action
1 For Data A, select and define FROM Slot ( i.e. , 0 Sys Ctrl ).
2 Select and define "from" Port (i.e., port 1 for T1: Data A).
3 Select and define From Config DS0s (i.e., DS0=9-24).
4
Select and define TO Slot and “to” Port in the same way (i.e.,
2 V.35Nx4 and 1 where 2 = Slot 2 and 1 = Port 1.)
5 From To Config, set V.35 to operate at 56k/64k per DS0.
6
Repeat for the remaining data connections (i.e., Data B and
Data C) as follows:
6a
Insert new connection lines by positioning the cursor over the
index # of the first connection and pressing
I .
6b
Copy the first connection by positioning the cursor on the index #
and pressing
C .