ADTRAN ATLAS 810 Plus - Manual (Page 93)

Chapter 8. Dedicated Maps Terminal Menu
61200266L1-1 ATLAS 810 PLUS User Manual 8-9
6c
Paste this information onto a new connection line by positioning
the cursor over the index numbers of the new connections, and
pressing
P .
7
Modify these connection lines to complete the connections for
data.
Instructions for Defining Voice Connections
Step Action
1
Select the FROM Slot and Port for the first voice connection (i.e.,
Slot 0/Port 1 for T1-A Voice).
2 Select the voice DS0s; i.e., 1 through 8 for Voice A.
3
Select the TO Slot and Port (PBX Connection); i.e., Quad T1/PRI
in Slot 1/Port 2.
4
From Configuration, set the starting DS0 that these voice DS0s
will appear in; i.e., 1 for Voice A; 9 for Voice B; 17 for Voice C. (This
action sets the DACSing between the T1s.)
5 Set RBS to On for the voice connections.
6
(Optional) From Configuration, set the trunk conditioning
(Signaling and Data code) for T1 failure.
7 Repeat for the remaining voice connections.
A connection is not actually “made” (connected) until the cursor
leaves the connection. The cursor leaves the connection when you
press ESC to move the cursor to the index # or when you move the
cursor onto another connection line.
Instructions for Defining Data Connections (Continued)
Step Action