ADTRAN ATLAS 810 Plus - Manual (Page 112)

Chapter 9. Dial Plan Terminal Menu
9-18 ATLAS 810 PLUS User Manual 61200266L1-1
» Interface Number Write security: 3; Read security: 5
Defines the interface number that uniquely identifies each additional inter-
face.
Quad T1/PRI Module (User Termination/RBS)
When you are working in the User Termination section of the Dial Plan
menu, Slot is defined as a T1/PRI module, and Sig is set to RBS, the follow-
ing configuration options are available:
»» First DS0/Number of
DS0s
Write security: 3; Read security: 5
Defines to ATLAS the DS0s which will be used for this endpoint. These are
the DS0s which will be used by ATLAS to send and receive calls to and from
User equipment (PBX). The incoming calls which will be accepted and the
outgoing calls which will be restricted over these DS0s are set by the Incom-
ing Call Accept and Outgoing Call Reject Numbers discussed earlier.
»» DS0s Available Read security: 5
Indicates which DS0s of the T1 have been defined in this switched endpoint
(indicated by “! “), in another switched endpoint (indicated by “s”), or in a
dedicated map (indicated by “n”).
»» Signaling Method Write security: 3; Read security: 5
Defines to ATLAS the type of signaling to be used across this trunk. The sig-
naling selected needs to match that being used by the user equipment (PBX).
The available options include E&M Immediate, E&M Wink, Loop Start, and
Ground Start.
»» Direct Inward Dialing Write security: 3; Read security: 5
Defines to ATLAS whether DID is being used by the Network. This option
only displays if Direct Inward Dialing (DID) is set to Enabled. If DID is
Enabled, then the following information must be defined:
DID Digits
Transferred Write security: 3; Read security: 5
Defines the number of digits sent to ATLAS from the Network if DID is
used.
ATLAS converts signaling types between Network and User
terminations.