ADTRAN ATLAS 810 Plus - Manual (Page 60)

Chapter 6. Terminal Menu and System Control
6-8 ATLAS 810 PLUS User Manual 61200266L1-1
» ADLP Address Write security: 2; Read security: 5
Shows the system ADTRAN Data Link Layer Protocol (ADLP) address for
connecting remote devices to management software (such as T-Watch PRO).
The allowable range is between 2 and 65520. Enter a value not used by any
of the TSU units controlled by the management software.
» Session Timeout Write security: 3; Read security: 5
Defines the number of seconds the terminal session must remain idle before
the session times out. You can enter zero to deactivate this option (the ses-
sion will never time out).
» Max Telnet
Sessions
Write security: 3; Read security: 5
Defines the maximum number of Telnet sessions that can be active at the
same time. Enter a number between 0 and 100 in this field.
» Ethernet Port Write security: 2; Read security: 5
Provides a way to configure various settings for the Ethernet port. The fol-
lowing options are available for review and editing:
»» Port Name Defines the name of the Ethernet port. You can leave this field blank.
»» IP Address Lists the address assigned to the base Ethernet port. This address is com-
posed of four decimal numbers, each in the range of 0 to 255, separated by
periods. This value is set to 0.0.0.0 by default. The IP address is used for the
10BaseT Ethernet interface. Obtain the correct IP address from your LAN
administrator.
»» Default Gateway Defines or changes the default gateway. Enter the default gateway address
by entering a decimal number into the appropriate field and then pressing
Enter to move to the next field. You will need a default gateway if the LAN
contains multiple segments. This address is composed of four decimal num-
bers, each in the range of 0 to 255, separated by periods. This value is set to
0.0.0.0 by default. Contact your LAN administrator for the appropriate ad-
dress.
»» Subnet Mask Defines which part of a destination IP address contains the network number.
This address is composed of four decimal numbers, each in the range of 0 to
255, separated by periods. This value is set to 0.0.0.0 by default. This part of
the destination IP address is used along with the ATLAS 810
PLUS
IP address
to determine which nodes must be reached through the default IP gateway.
»» MAC Address Displays the system Ethernet Media Access Control (MAC) address.
If you enter zero in this field, you will not be able to use Telnet. Only
enter zero if you want to completely lock out Telnet access.