ADTRAN ATLAS 810 Plus - Manual (Page 71)

Chapter 6. Terminal Menu and System Control
61200266L1-1 ATLAS 810 PLUS User Manual 6-19
To support these transfers, ADTRAN delivers a TFTP program with
ATLAS 810
PLUS
called TFTP Server. You can configure any PC running Mi-
crosoft Windows with this software, and store a configuration file. See TFTP
Server on page 12-10 for details on how to use TFTP Server.
Only one configuration transfer session (upload or download) can be active
at a time. The TCP/IP parameters are not saved or overwritten as part of an
ATLAS 810
PLUS
unit’s transferred configuration; this way, identical config-
urations can be sent to multiple units.
»» Transfer Method Write security: 3; Read security: 5
Displays the method used to transfer the configuration file to or from a
server. Currently, you must use TFTP.
»» TFTP Server IP
Address
Write security: 3; Read security: 5
Specifies the IP address of the TFTP Server. Get this number from your sys-
tem administrator.
»» TFTP Server
Filename
Write security: 3; Read security: 5
Defines the name of the configuration file that you transfer to or retrieve
from the TFTP Server. The default name is
atlas.cfg , but you can edit this
name.
»» Current Transfer
Status
Read security: 5
Indicates the current status of the update.
»» Previous Transfer
Status
Read security: 5
Indicates the status of the previous update.
»» Load and Use Config Write security: 3; Read security: 5
Retrieves the configuration file specified in the
TFTP Server Filename field
from the server. To start this command, enter Y to begin or enter N to cancel.
Before using Config Transfer , the ATLAS 810
PLUS
should have a
valid IP address, subnet mask, and default gateway (if required),
and should be connected to an Ethernet network.
If you execute Load and Use Config , the ATLAS 810
PLUS
retrieves the configuration file, reboots, then restarts using the new
configuration.