ADTRAN ATLAS 810 Plus - Manual (Page 111)

Chapter 9. Dial Plan Terminal Menu
61200266L1-1 ATLAS 810 PLUS User Manual 9-17
»» Outgoing Caller ID Write Security: 3 Read Security: 5
Allows the user to insert a called ID to outgoing calls (coming in from
attached User equipment). If set to
6HQGýDVý3URYLGHG , then ATLAS will for-
ward whatever ID it receives (including none). If set to 6XEVWLWXWHýLIýQRWý
SUHVHQW , then ATLAS inserts a User-defined ID value if no value is received.
If set to 6XEVWLWXWHý$OZD\V , then ATLAS always inserts the User-defined ID
in place of the value received.
» ID Presentation Defines control information for the presentation of Caller ID ( 3UHVHQWDWLRQý
$OORZHGâý3UHVHQWDWLRQý5HVWULFWHGâý1XPEHUý1RWý$YDLODEOH ).
» ID Number Value for Caller ID to be sent to the Network (i.e., 256 963 8020).
» Source ID Simplifies the creation of a Dial Plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
• Default value = 0. The default ID for all endpoints is 0 and all accept # s
is 0. With default values, all calls are routed based only on dialed num-
ber.
• Multiple endpoints can have the same Source ID .
• When creating the Call Accept list, specify a Source ID (s) as well as a di-
aled number or range of dialed numbers to accept.
For example, an application requires that all calls originating from Port 1 of
the Quad T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. Assign a unique
Source ID (e.g., 7) to Port 1 of the module, and then
configure Port 4 to only accept calls from that unique Source ID (7).
»» Swap ANI/DNIS Swaps the ANI and DNIS numbers prior to being forwarded to the attached
user equipment. ANI (Automatic Number Identification) is the billing
number of the calling party, and DNIS (Dialed Number Identification Ser-
vice) is the called party number.
Quad T1/PRI Module (User Termination/NFAS)
When you are working in the User Termination section of the Dial Plan
menu, Slot is defined as a T1/PRI module, and Sig is set to NFAS, the fol-
lowing configuration menu is available (in addition to the standard User
Termination/PRI configuration menus and options):
» Secondary
Interfaces
Write security: 3; Read security: 5
Defines the additional PRI interfaces controlled by the D-channel on this
endpoint.
» Slot, Port Write security: 3; Read security: 5
Defines the slot and port in which the additional interface terminates.
This swap occurs after the ATLAS switchboard has routed the call.
The accept number in the Dial Plan must use the number in the
DNIS position prior to swapping.