ADTRAN ATLAS 810 Plus - Manual (Page 114)

Chapter 9. Dial Plan Terminal Menu
9-20 ATLAS 810 PLUS User Manual 61200266L1-1
Quad Nx56/64 Module (User Termination)
When you are working in the User Termination section of the Dial Plan
menu, and Slot is defined as a QuadNx56/64 module, the following inter-
face configuration options are available:
»» Ports Available Indicates which of the four ports of the Quad Nx56/64 module have
already been defined either in another switched endpoint (indicated by “s”)
or in a dedicated map (indicated by “n”). This field is read-only.
»» Number of Ports Defines to ATLAS how many of the ports could be used to answer calls to
the number(s) defined in the Accept Call list. You can enter numbers 1
through 4. The ports are contiguous beginning with the port number select
and the number of ports.
For example, if the port selected (as a part of Slot/Port selection) is 2, and
the number of ports selected here was 2, then ports 2 and 3 would be
enabled to receive calls to the numbers listed under the Incoming Call
Accept list.
Octal BRI Module (Network Termination)
The Octal BRI with a “U” interface can interface directly to the Network
(PSTN). When you are working in the
Network Termination section of the
Dial Plan menu and Slot is defined as a UBRI-8 option module, the follow-
ing interface configuration options are available:
»» Switch Type Write security: 2; Read security: 5
Defines the type of ISDN switch that ATLAS is connected to. If connected to
another ATLAS, both need to be set to the same type. The available options
are Lucent 5E, Northern DMS 100, and National ISDN.
»» SPID List Write security: 2; Read security: 5
In order to properly operate with a network (PSTN) ISDN switch, the BRI in-
terface must have SPID (Service Profile Identifier) and phone number(s) that
match the SPID(s) and phone number(s) which have been programmed into
the ISDN switch for this line. Each BRI may have one or more phone num-
bers and SPIDs. The
SPID Number list submenu defines to ATLAS these pa-
rameters.
Phone Number The phone number(s) assigned to this BRI phone line.
SPID Number This entry must match the SPID number(s) which have been set in the Net-
work’s ISDN switch (or in the PBX) for this BRI line. A SPID must be entered
for each phone number.
The Quad Nx56/64 can only serve as a User termination endpoint.