ADTRAN ATLAS 810 Plus - Manual (Page 80)

Chapter 7. Modules Terminal Menu
7-4 ATLAS 810 PLUS User Manual 61200266L1-1
Modules Menu (Quad T1/PRI)
This section provides detailed information on the Modules / Menu sub-
menus. Menu provides access to commands that allow you to review the sta-
tus of various options, change the configuration for general parameters, and
initiate tests. This section only describes the menu options for the Quad T1/
PRI controller port (the ATLAS 810
PLUS
Base Unit). For details on menu op-
tions for individual modules, refer to the appropriate module manuals.
»» Controller Info Read security:5
Displays general information about the ATLAS 810
PLUS
Base Unit and
Quad T1/PRI ports as follows:
Part Num Displays the part number of the ATLAS 810
PLUS
.
PLL Status (Phase Lock Loop) Indicates whether the clock is locked to its specific
source.
»» Alarm Status Read security:5
Displays any active alarms as follows:
Prt Port number displayed.
Alarms Displays alarm type. Table 7-1 describes each alarm type.
Table 7-1. Alarm Types
LOS (Loss of Signal) No signal detected on port interface.
RED (Red Alarm) Not able to frame data received on the port. Alternately referred to as Out
of Frame (OOF).
YELLOW (Yellow Alarm) Remote alarm indicator (RAI) being received on port.
BLUE (Blue Alarm) Receiving unframed all ones from the port alarm indicator signal (AIS).
DS0 ALARM HDLC framing is operational on PRI D channel. This indication only applies when
operating in PRI mode.
RX LEVEL (Receive Level) Indicates the strength of the signal received on the port.