Thermo Fisher Scientific CyberScan pH 5000 - Manual (Page 28)

Instruction Manual CyberScan pH5500/ 5000
This screen allows you to turn on or off the beeper. You may choose
to have an audible signal when the meter recognizes that the current
measurement is stable, each time a function button is touched and/ or
when the set limits of a measurement mode have been exceeded.
After stable reading
When active, the meter delivers an audible tone each time the meter
recognizes the current measurement as stable. If deactivated, you
will not hear an audible tone at a stable measurement. You will still
see the STABLE indicator even if there is no audible tone.
After key activation
When active, the meter delivers an audible tone each time you touch
a function button or a key on an alphanumeric keypad. If deactivated,
you will not hear a tone after a key touch. The changes will only be
visible on the screen.
On LIMIT Exceeded
When active, the meter delivers an audible tone each time the set
limits in a measurement mode have been exceeded. If deactivated,
you will not hear an alarm tone when the limits in the measurement
modes have been exceeded. You will see the LIMIT indicator on the
measurement screen. For additional information on the alarm limits of
the meter, see the setup sections of this manual for each of the
measurement modes.
To Set Beeper Status
1. Access the set beeper status screen from the System Setup
screen. The current beeper status is displayed on the screen.
2. Use the arrow keys to highlight the beeper status option that you
would like to modify.
3. Touch ON or OFF until the desired status is visible in the current
beeper status box.
4. Touch save to accept the change sand return to the System
Setup screen.
OR
Touch exit to return to the System Setup screen without making
any changes.
23