Thermo Fisher Scientific CyberScan pH 5000 - Manual (Page 81)

Instruction Manual CyberScan pH5500/ 5000
To Set Sample ID#
When this option is active, each time you touch print on the Measure
screen the mV value along with the date/time/channel and the sample
ID# will be sent to data storage. You can manually enter an
alphanumeric identification number of up to 10 characters for any
sample, or you can have the meter sequentially number your samples
beginning at the number of your choice. You may also choose to
deactivate the sample ID#.
The mV Sample ID# is set the same way as previously described in
pH setup. See page 46 for instructions.
To Set Alarm Limit
This option allows you to set alarm limits for the mV measuring mode.
If the mV value of the measurement is outside of the boundaries set
by the upper and lower limits, an audible alarm and/ or a visual
warning will appear to let you know that your sample measurement
was outside of the set limits.
The mV alarm limits are set the same way as previously described in
pH setup. See page 62 for instructions.
To Set Print Criteria
This screen allows you to select which criteria are printed with the
measurement when you print the data or send it to the computer. The
status of the current print criteria is displayed on the screen. The
criteria option is active if “ON” appears to the right of the option. It is
inactive if “OFF” appears to the right of the option. Any active criteria
will be printed on demand.
The mV Print Criteria are set the same way as previously described
in pH setup. See page 64 for instructions.
Remember, HELP is always just a touch of the button away.
76