West Control Solutions Pro-EC44 - Manual (Page 69)

Pro-EC44 2-Loop Graphical Profile Controller & Recorder
Pro-EC44 Product Manual - 59540-1 October 2013 Page 62
Recorder Control Menu
This menu allows the user to manually start a recording or to delete previous recordings.
Refer to the Recorder Configuration sub-menu in Configuration Mode for information about
how to setup the data to be recorded and the recording interval and the Data Recorder
Option section on page 97 for general information about the recorder feature.
Entry into the Recorder Control Menu
The Recorder Control Menu is entered from the Main Menu
Hold down
R
and press
U
to enter the Main Menu.
Press
D
or
U
to select the Recorder Control Menu
Press
R
to enter the Recorder Control Menu.
Navigating the Recorder Control Menu
Press
R
to move forward, or
L
to move backwards through parameters & screens.
Holding down
R
or
L
for more than 1 second skips immediately to the next/previous
screen accepting ALL values as shown.
Press
D
or
U
to select or change the value as required.
The next/previous screen follows the last parameter. If no further changes are
required, hold down
R
or
L
>1sec to skip straight to next/previous screen accepting
ALL values shown.
Hold down
R
and press
U
to return to the Main Menu
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
 RECORDER MENU SCREENS
Recorder Mode
Unlocking Enter correct code number to access the Data Recorder Menu.
Factory Default value is 10.
Recording In
Progress Warning Shown if a recording is in progress when the recorder control menu is
entered.
Start/Stop Data
Recording Turn on or off the manual recording trigger.
Note: Recording continues if another record trigger is active (e.g.
on alarm/profile or via a digital input). Access is restricted to this
screen only until recording stops (remove all active triggers).
Note: Entry into this mode is security-protected by the recorder control menu
lock code. Refer to the Lock Code Configuration sub-menu.