West Control Solutions Pro-EC44 - Manual (Page 73)

Pro-EC44 2-Loop Graphical Profile Controller & Recorder
Pro-EC44 Product Manual - 59540-1 October 2013 Page 66
Event n  Select the events to be active during this segment. n = 1 to 5.
Note: For end segments, the events selected to be active stay on until the
instrument exits from profiler mode or a new profile runs.
Note: For end segments, the events selected to be active stay on until
the instrument exits from profiler mode or a new profile runs.
Edit A Profile
Header
 Choose the profile to be edited from the list of names provided, then alter
any values as required – The profile header details are as shown in “Create
A Profile” above.
Edit A Profile
Segment
 Choose the profile, then the segment to be edited from the lists provided.
Alter any values as required – The profile segment details are as shown in
“Create A Profile” above.
Note: The last segment type can only be set to Join, End or Repeat
Sequence Then End. Use Insert or Delete to change the end position.
Insert A Segment
 Choose the profile, then the new segment’s position from the lists provided
– Enter the new segment values as required – The profile segment details
are as shown in “Create A Profile” above.
Note: The new segment type cannot be set to Join, End or Repeat
Sequence Then End. Use Delete to change the end position.
Delete A Segment
 Choose the profile, then the segment to be deleted from the lists provided.
End, Join or Repeat segments cannot be deleted.
Delete A Profile
 Choose the profile to be deleted from the list of names is provided. The
user is prompted confirm the deletion.
Delete All Profiles
 If selected, the user is prompted to confirm that the profiles should be
deleted
.
Caution: This deletes all profiles from memory!
Profiler Control Menu
 PROFILER CONTROL MENU SCREENS
Profiler Control
Menu Unlocking Enter correct code number to access Profiler Control Menu.
Factory Default value is 10.
Profile Control If a profile is running, from: Do Nothing; Abort Profile (end immediately); or
Jump to Next Profile Segment; Hold Profile or Release Hold.
If profile not running, from: Do Nothing; Run Profile; End Profile Control
(return to normal controller operation) or Select Profile.
Select Profile
Selects a profile. If Run Profile was chosen in the previous screen, the
profile starts (after a delay if one is enabled). Otherwise the profile is
selected, but waits for a run instruction (e.g. via digital input or timer).
Note: Selection is “read only” if profile selection is via a digital input.
Otherwise choose from the list of profile names provided.