Brother PE-DESIGN Ver.5 - Manual (Page 101)

93
Contents
Before Using
Getting Started
Design Center
Layout & Editing
Programmable Stitch Creator
Quick Reference
Alphabetic Index
Operation:
1
Select one or more outline data (Stage 3 only).
2 Click Edit , then Delete .
The selected outline data are removed from the screen. Since they are not saved in the clipboard,
the only way to make them reappear is to use
Edit – Undo .
See also: “Undo” and “Cut” on page 91
■
Mirror – Horizontal
Purpose: Flips the selected data up/down.
Shortcut key: +
Toolbar:
Operation:
1 Select one or more outline data (Stage 3 only).
2 Click Edit , then Mirror , then Horizontal .
A horizontal mirror image (top and bottom inverted) of the outline data appears on the screen.
Two successive executions of this command restores the original image.
See also: “Flipping a pattern horizontally or vertically” on page 67 and “Mirror – Vertical”
below
■
Mirror – Vertical
Purpose: Flips the selected data left/right.
Shortcut key: +
Toolbar:
Operation:
1
Select one or more outline data (Stage 3 only).
2 Click Edit , then Mirror , then Vertical .
A vertical mirror image (left and right inverted) of the outline data appears on the screen.
Two successive executions of this command restores the original image.
See also: “Flipping a pattern horizontally or vertically” on page 67 and “Mirror – Horizontal”
above
Ctrl H
Ctrl J