Brother PE-DESIGN Ver.5 - Manual (Page 63)

55
Contents
Before Using
Getting Started
Design Center
Layout & Editing
Programmable Stitch Creator
Quick Reference
Alphabetic Index
By attaching the enclosed (or optional) multi-position frame (130
× 300 mm or 100 × 172 mm) at each of
its three installation positions, multi-position designs can be embroidered.
With this program you will be able to create designs that you can stitch in any multi-position hoop.
(Jumbo Hoop and Extra Large Hoop)
Although the size of the pattern that can be embroidered using an multi-position frame is 130
× 180 mm
(or 100
× 100 mm, depending on the sewing area of the embroidery machine), first determine which of
the three installation positions (indicated as a, b, and c in the illustration above) the multi-position frame
will be installed at and determine the orientation of the data.
When creating the pattern, each design section can only be as large as the sewing field of the machine.
■
Select the Design Page size
1
In Layout & Editing , click Option , then Design Page Property .
NOTE:
The Design Page size in dialog shown above is not available in Design Center since the maximum
sizes for a single pattern are 260
× 160 mm, 130 × 180 mm, and 100 × 100 mm. Remember that
260
× 160 mm size cannot be used for a multi-position frame.
◆ From the
Size selector, choose a
Design Page size of 130
× 300 mm,
300
× 130 mm, 100 × 172 mm, or 172 ×
100 mm.
(Settings for multi-position frames are
indicated by “*”.)
• Choose the appropriate setting after
checking the size of the embroidery
frame available for your machine.
Creating data for the multi-position frame
a
b
c
a
b
c
ABC
Example of Multi-Position Frame: 100
× 172 mm embroidery frame