Brother PE-DESIGN Ver.5 - Manual (Page 27)

19
Contents
Before Using
Getting Started
Design Center
Layout & Editing
Programmable Stitch Creator
Quick Reference
Alphabetic Index
Step 3
Converting to Line Image
1 Move to line image: Click Stage on the menu bar, then click To Line Image on the submenu. You can
also click the button of the Toolbar shown below:
NOTE: Many menu functions can be activated by clicking a button on the Toolbar.
The Cut out to Line Image dialog will display. In this dialog, you will select the color(s) that will be
used to make the outline of the image.
2 When you click OK , the line image displays.
◆ If necessary, scroll and zoom the image.
◆ Move the cursor over the image. Its shape
changes to . Click on any point of the out-
line. The selected color displays in the upper
box under Pick Colors and a appears in the
check box to show that the color is selected.
• When the outline of the image uses more than one
color, you can repeat to select a total of five colors.
If you try to select more, colors are scrolled down,
and the color that was at the bottom is deselected.
• If you selected a color by mistake, simply click
its check box to deselect it.
◆ Click
View to see the effect of your selection.
• If you wanted to select another choice of color,
click
Cancel . The image displays again and you
can repeat this step with another color.
◆ If your preview image looks like the one shown
here, click OK to confirm the outline of your pattern.
◆ Click
Cancel to exit and go back to the image.
◆ If necessary, click
Image Tune to reduce the col-
ors or the noise. (page 109)
• At this stage, the data can be saved as a *.pel
file.
To Line Image