Canon PowerShot S110 - Manual (Page 301)

301
Using an Eye-Fi Card
Images labeled with a [ ] icon have been transferred.
• Choosing [ ] mode will interrupt the Eye-Fi connection. Although the Eye-Fi
connection will be restored after you choose another shooting mode or enter
Playback mode, the camera may transfer any movies made in [ ] mode
again.
Checking Connection Information
Check the access point SSID used by the Eye-Fi card or the connection
status, as needed.
z z Press the < n> button, choose
[Eye-Fi Settings] on the [ 3] tab, and then
press the < m> button.
z z Choose [Connection info], and then press
the < m> button.
X X The connection information screen is
displayed.
Disabling Eye-Fi Transfer
Configure the setting as follows to disable Eye-Fi transfer by the card, if
necessary.
Choose [Disable] in [Eye-Fi trans.].
z z Press the < n> button, choose
[Eye-Fi Settings] on the [ 3] tab, and then
press the < m> button.
z z Choose [Eye-Fi trans.], and then choose
[Disable].
• [Eye-Fi Settings] is not shown unless an Eye-Fi card is in the
camera with its write-protect tab in the unlocked position. For this
reason, you cannot change settings for an inserted Eye-Fi card if
the write-protect tab is in the locked position.
COP
Y