Agilent Technologies N2620A User Manual
Page 199
System Operations
7
N2620A User’s Guide
181
Press Edit Settings to call the Auxiliary Port Setup screen to
change the network settings of the Auxiliary port.
•
MAC Address - The MAC Address panel of the FrameScope
Pro usually contains the value set in the factory. But this
field can be used to change the MAC address if it is necessary
for a specific case or to meet the security requirements.
Enable Restore Default MAC in the System Settings Network
menu to reset the MAC address to the factory default on the
next power-on.
C A U T I O N
MAC address modification is not advisable. If a modification is
unavoidable, the changes should be done with extreme care so that it will
not conflict with any MAC address that is in use.
N O T E
The FrameScope Pro supports only one default gateway. If you need to
configure the test and auxiliary ports in different subnets and the
gateways to these subnets are different, add the interface and gateway
for accessing the second remote network to the routing table, as
described in