Agilent Technologies N2620A - Manual (Page 211)

System Operations 7
N2620A User’s Guide 193
RFC 2544 Test
Two FrameScope Pro units or one FrameScope Pro and a
loopback device are needed for the RFC 2544 tests: round-trip
latency test, point-to-point throughput test, frame loss rate
tests, and back-to-back tests. One FrameScope Pro will be the
master and the other the slave (if two FrameScope Pro units are
used), which are placed in the network-point-under-test. The
slave FrameScope Pro has to be preset for the RFC 2544 tests.
The RFC 2544 Test Slave Setup screen allows you to enable the
FrameScope Pro to take the part as the slave device in RFC 2544
tests.
A password can also be assigned for extra security.
Refer to Chapter 2 , “Setting Up the Slave FrameScope Pro for
RFC 2544 Tests” on page 62 for the procedure to set up the slave
FrameScope Pro.