HP LaserJet 3100 All-in-One Printer series - Manual (Page 190)

EN 9 Troubleshooting and Maintenance 189
No Memory for
Report
Erase/Print
Document Memory needed to print a report may be
being used to store faxes that have been
received to memory.
Needed memory may be being used to
store faxes set up to be sent at a future
time or to be polled.
Print faxes that have been received to
memory (see “Printing faxes received to
memory” in chapter 3).
If you have several faxes set up to be
sent at a future time or to be polled, try
clearing these faxes using Job Status
(see “Canceling a fax job using Job
Status” in chapter 3).
No Modem Installed There is a problem with the LIU. Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord. If the error persists,
service may be required. See the front
of this manual for support information.
No Room in Fax Log The fax log was unable to print due to an
error, such as out of paper. Load paper in the paper input bin so the
HP LaserJet 3100 product can print the
log.
Not Enough Memory There is not enough memory to complete
the job indicated. Try resending the job. If the error
persists, try reducing the amount of
activity on the HP LaserJet 3100
product and cancel jobs in memory
before resending the job.
Not Enough Memory
to Duplicate for
COPY The HP LaserJet 3100 product does not
have enough memory to complete the
copy job. Divide the copy job into smaller sections
and then try copying again.
If you are collating the job, turn off the
collation feature (chapter 8), only make
one copy of the document at a time, or
use the Document Assistant to make the
copies.
No Fax Pages in
Memory to Reprint The HP LaserJet 3100 product attempted
to execute “Reprint Last Fax” when
nothing was in memory. Wait for a fax, then as soon as a fax is in
the memory, the HP LaserJet 3100
product will reprint the fax.
Nov-22-93 06:30 PM
(An incorrect date
appears.) The battery inside the HP LaserJet 3100
product has failed, causing all Menu
features to revert to the factory settings.
Settings that contained alphabetic and
numeric characters you entered, such as
header information and speed-dial names
and numbers, have been erased. You can continue to use the HP
LaserJet 3100 product without the
battery, but if you re-enter the Menu
settings and then turn off the power, the
settings are erased again.
To obtain service, you must contact
HP’s customer support center. See the
front of this manual for support
information.
Message Cause Solution