HP LaserJet 3100 All-in-One Printer series - Manual (Page 36)

EN 1 Set Up 35
Using the CD-ROM or floppy disks
The software was shipped on CD-ROM. If you need floppy disks, you
can make them (if you have access to another computer with a
CD-ROM drive) or order them. To make floppy disks, see “Creating
floppy disks from the CD-ROM” in this chapter. To order floppy disks,
or a replacement CD-ROM if yours is damaged, see “Ordering
software” in chapter 9.
Installation instructions
Follow the installation instructions for your operating system.
To install the software on Windows 95/NT 4.0
Note To install the software on Windows NT 4.0, you must log on with
administrator privileges.
1 If the “New Hardware Found” screen has opened, click Cancel.
2 Quit all open programs.
3 For the CD-ROM: Insert the CD-ROM into the CD-ROM drive
(usually D). When the welcome screen opens, follow the
directions on screen. If the welcome screen does not open, click
Start, and then Run. Type
X:SETUP , replacing “ X ” with the letter
of your drive, and click OK.
For floppy disks: Insert Disk 1 into the floppy disk drive (usually
A or B). Click Start, and then Run. Type
X:SETUP , replacing “ X ”
with the letter of your drive, and click OK.
4 Follow the instructions on the screen. The setup takes a few
minutes. When it is complete, remove the CD-ROM or last floppy
disk.
5 Print a test page. See “Printing a test page” later in this chapter.