HP LaserJet 3100 All-in-One Printer series - Manual (Page 73)

72 3 Faxing EN
Inserting a pause while dialing
You can insert pauses into a fax number you are dialing or
programming to a one-touch key, speed-dial code, or group-dial
code. Pauses are often needed when dialing internationally.
Press R EDIAL /P AUSE to enter a two-second pause in your dialing
sequence. A comma appears on the control panel display, indicating
that the pause will occur at that point in the dialing sequence.
If you enter the pause at the end of a number you are programming
into a one-touch key, speed-dial code, or group-dial code, the HP
LaserJet 3100 product waits to dial this number until you enter
another number. (This is also known as concatenated dialing.)
Using special dialing symbols
After enabling special dialing symbols, you can use them when
dialing a fax number or entering a fax number for a one-touch key,
speed-dial code, or group-dial code.
Note Before using special dialing symbols such as hook flash, you must
enable them. See “Enabling special dialing symbols” in chapter 8.
To use special dial symbols
1 When you reach the position in the fax number where you need
the symbol, press
* .
2 Use the < and > keys to scroll through the symbols until you
reach the one you need and press E NTER /M ENU .
3 The special symbol is entered into the fax number. It will be
represented by a letter or punctuation mark.
- Or -
Depending on the symbol you chose, you may be asked to make
additional choices before the symbol is entered into the fax
number.