HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem User Manual
HP Computer Accessories
Advertising
This manual is related to the following products:
1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem, Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem, Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem, Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem, 4GB Virtual Connect Fibre Channel Module for c-Class BladeSystem, Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem, Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem
Table of contents
Document Outline
- HP Virtual Connect Manager Command Line Interface for c-Class BladeSystem Version 3.30 User Guide
- Abstract
- Notice
- Contents
- Introduction
- Command line
- Subcommands
- Managed elements
- all
- version
- banner
- config
- configbackup
- devicebay
- domain
- enclosure
- enet-connection
- enet-vlan
- external-manager
- fabric
- fc-connection
- fcoe-connection
- firmware
- igmp
- igmp-group
- interconnect
- interconnect-mac-table
- iscsi-boot-param
- iscsi-connection
- ldap
- ldap-certificate
- ldap-group
- link-dist-interval
- lldp
- log-target
- loop-protect
- mac-cache
- nag-network
- network
- network-access-group
- network-range
- port-monitor
- profile
- radius
- radius-group
- role
- server
- serverid
- server-port
- server-port-map
- server-port-map-range
- snmp
- snmp-trap
- ssh
- ssl
- ssl-certificate
- ssl-csr
- stackinglink
- statistics
- statistics-throughput
- status
- storage-management
- supportinfo
- systemlog
- tacacs
- uplinkport
- uplinkset
- user
- user-security
- vcm
- User privileges
- Help subsystem
- Output format
- Statistics descriptions
- Configuring the Virtual Connect domain using the CLI
- Basic configuration
- Logging in to the CLI
- Domain setup
- Network setup
- Configuring MAC address ranges
- Creating a network access group
- Creating an Ethernet network
- Adding Ethernet networks to a network access group
- Creating an Ethernet network that uses network access groups
- Adding uplink ports to an Ethernet network
- Creating a shared uplink set
- Adding uplink ports to a shared uplink set
- Creating a network that uses a shared uplink set
- Creating multiple networks that use a shared uplink set
- Server VLAN Tagging Support
- Fibre Channel setup
- Serial number settings
- Server profile setup
- Creating server profiles
- Adding Ethernet network connections to a profile
- Adding iSCSI connections to a profile
- Adding FC fabric connections to a server profile
- Adding FCoE connections to a profile
- Adding a network access group to a profile
- Assigning a server profile to a device bay
- Configuring IGMP settings
- Configuring MAC cache failover settings
- Configuring network loop protection settings
- Server blade power on and power off guidelines
- General requirements for adding FC or FCoE connections
- Logging out of the CLI
- Common management operations
- Port status conditions
- Resetting the Virtual Connect Manager
- Basic configuration
- Technical support
- Acronyms and abbreviations
- Index