HP XP7 Storage - Manual (Page 116)

Corrective action Description Path status
The secondary system's S/N
does not match the specified
S/N. Serial Number
Mismatch • Make sure that you entered the correct secondary system
S/N and Controller ID, and primary and secondary system
port numbers.
•
Make sure the primary and secondary system ports are
configured correctly.
• Make sure that data path relay equipment is properly
configured and functional. This includes cables, connectors,
switches, extender devices, communication lines, and all
other devices connected to the extenders.
The specified port is not
configured as an initiator Invalid Port Mode •
Make sure the correct port on the primary system is
configured as an initiator port.
port, or this path already
exists.
• Make sure that no two paths between primary and
secondary system ports have the same settings.
•
Make sure that you entered the correct secondary system
S/N and Controller ID, and primary and secondary system
port numbers.
•
Make sure that the primary and secondary system ports are
configured correctly.
• Make sure that data path relay equipment is properly
configured and functional. This includes cables, connectors,
switches, extender devices, communication lines, and all
other devices connected to the extenders.
The specified port in the
secondary system is Pair-Port Number
Mismatch •
Make sure that you specified the correct secondary system
port number. Correct the port number if necessary.
physically disconnected from
the primary system.
• Make sure that the cables between the primary and
secondary system ports and between the primary and
secondary system switches are connected correctly.
•
Make sure that the topology settings of the primary and
secondary system ports are correct.
Make sure that the secondary system port is configured as an
RCU target port. The specified secondary
system port is not configured
as an RCU target port. Pair-Port Type Mismatch
The primary system connected
to the secondary system Communication Failed •
Make sure that the secondary system port and the relay
equipment are configured correctly.
successfully, but logical
•
Make sure that data path relay equipment is properly
configured and functional. This includes cables, connectors,
communication timeout
occurred.
switches, extender devices, communication lines, and all
other devices connected to the extenders.
Wait until processing is completed. Paths are being created or
deleted, or the port attribute
is being changed. In Progress
See the following. Blockaded due to continual
path or link failure. Logical Blockade
Repair the port on the primary system, then restore the path
*
. The primary system port does
not work.
Repair the port on the secondary system, then restore the path
*
. The secondary system port
does not work.
Repair the path relay equipment, then restore the path
*
. The path relay equipment
does not work.
Replace the broken cable, then restore the path
*
. The connection cable is
physically broken.
116 Cnt Ac-J Z troubleshooting