HP XP7 Storage - Manual (Page 78)

If a journal includes two mirrors:
•
If you specify a mirror in Hold, Holding, or Hold(Failure) status, only the Cnt Ac-J Z pairs of
the specified mirror are deleted.
•
If you specify a mirror that is not in Hold, Holding, or Hold(Failure) status, Cnt Ac-J Z pairs of
both mirrors (including the mirror that you did not specify) are deleted.
Procedure 16 To delete pairs in a mirror
1. In the Storage Systems tree, click Replication > Remote Replication, and then select the Mirrors
tab.
2. From the list, select the mirrors to be deleted.
3. From the Actions menu, click Remote Replication > Delete Mirrors.
4. In the Delete Mirrors dialog box, review the mirrors in the Selected Mirrors table.
5. For Delete Mode, specify one of the following:
•
Normal: Mirrors are deleted only if the primary system can change the mirror status to
Initial.
•
Force: Mirrors are forcibly deleted even when the primary system cannot communicate
with the secondary system.
6. Click Finish.
7. In the Confirm window, review the settings and enter a task name in the Task Name box.
8. Click Apply to save your settings to the system.
NOTE: If the journal (mirror) status is not Initial—even though you deleted pairs forcibly and five
minutes have passed—perform the operation again to delete all pairs registered to the mirror.
Do not create pairs with the same journal for at least five minutes, even if the journal status was
Initial; otherwise pair creation could fail and the pair would be suspended.
78 Cnt Ac-J Z pair operations