HP Photosmart 3310 All-in-One Printer User Manual
Page 172
connected to the HP All-in-One and plugged into a power outlet. Press the
On
button to turn on the HP All-in-One.
After turning on the HP All-in-One, HP recommends you wait five minutes before
sending or receiving a fax. The HP All-in-One cannot send or receive faxes while
it is initializing after being turned on.
Solution
●
Make sure you used the phone cord supplied in the box with your HP All-in-
One to connect to the telephone wall jack. One end of the phone cord should
be connected to the port labeled "1-LINE" on the back of your HP All-in-One
and the other end to your telephone wall jack, as shown below.
1 Telephone wall jack
2 Phone cord supplied in the box with your HP All-in-One
If the supplied phone cord is not long enough, you can extend it. For
information see
The phone cord that came with my HP All-in-One is not long
●
Try connecting a working phone and phone cord to the telephone wall jack
that you are using for the HP All-in-One and check for a dial tone. If you do
not hear a dial tone, contact your telephone company and have them check
the line.
●
Other equipment, which uses the same phone line as the HP All-in-One,
might be in use. For example, you cannot use your HP All-in-One for faxing if
an extension phone is off the hook, or if you are using your computer modem
to send an e-mail or access the Internet.
●
Check to see if another process has caused an error. Check the color
graphics display or your computer for an error message providing information
about the problem and how to solve it. If there is an error, the HP All-in-One
will not send or receive a fax until the error condition is resolved.
●
The phone line connection might be noisy. Phone lines with poor sound
quality (noise) can cause faxing problems. Check the sound quality of the
phone line by plugging a phone into the telephone wall jack and listening for
static or other noise. If you hear noise, turn
Error Correction Mode
(ECM)
off and try faxing again. For information about changing ECM, see the
User Guide
169
Troubleshooting