HP Photosmart 3310 All-in-One Printer - Manual (Page 81)

General network settings
The following table describes the general network settings shown on the network
configuration page.
Parameter Description
Network Status Status of the HP All-in-One:
●
Ready: The HP All-in-One is ready to receive or transmit data.
● Offline: The HP All-in-One is not currently connected to the
network.
Active
connection type Network mode of the HP All-in-One:
●
Wired: The HP All-in-One is connected by Ethernet cable to
an IEEE 802.3 network.
● Wireless: The HP All-in-One is connected wirelessly to an
IEEE 802.11b or g network.
● None: There is no network connection.
Note Only one connection type can be active at a time.
URL The IP address of the Embedded Web Server.
Note You will need to know this URL when you try to access the
Embedded Web Server.
Firmware
Revision The internal networking component and device firmware revision
code.
Note If you call HP Support, depending on the problem, you
might be asked to provide the firmware revision code.
Hostname The TCP/IP name assigned by the installation software to the
device. By default, this is the letters HP followed by the last 6
digits of the Media Access Control (MAC) address.
Admin
Password Status of the administrator's password for the Embedded Web
Server:
●
Set: Password is specified. You must enter the password to
make changes to the Embedded Web Server parameters.
● Not Set: No password is set. A password is not required for
making changes to the Embedded Web Server parameters.
mDNS Rendezvous is used with local and ad hoc networks that don't use
central DNS servers. To perform name services, Rendezvous
uses a DNS alternative called mDNS.
With mDNS, your computer can find and use any HP All-in-One
connected to your local area network. It can also work with any
other Ethernet-enabled device that appears on the network.
Chapter 4
78 HP Photosmart 3300 All-in-One series
Netw
ork
setup