HP Photosmart 3310 All-in-One Printer User Manual
Page 65
4.
Press
4
.
This runs the
Wireless Setup Wizard
. The setup wizard searches for available
networks, and then displays a list of detected network names (SSIDs). The
infrastructure networks appear first in the list. The networks with the strongest
signal appear first, the weakest appear last.
5.
Press to highlight the name of the network you wrote down in step 1, and then
press
OK
.
If you do not see your network name in the list, do the following:
a.
Select
Enter a New Network Name (SSID)
. If necessary, use the to
highlight it, and then press
OK
.
The visual keyboard appears.
b.
Enter the SSID. Use the arrow buttons on the HP All-in-One control panel to
highlight a letter or number on the visual keyboard, and then press
OK
to
select it.
For more information on using the visual keyboard, see
Note
You must enter the exact uppercase (capital) and lowercase
(small) letters. Otherwise, the wireless connection will fail.
c.
When you are finished entering the new SSID, use the arrow buttons to
highlight
Done
on the visual keyboard, and then press
OK
.
d.
Press
1
to select the infrastructure mode.
e.
Press
2
to select WEP encryption.
OR
Press
3
to select WPA encryption.
6.
If prompted, enter your WPA or WEP key as follows:
a.
Use the arrow buttons to highlight a letter or number on the visual keyboard,
and then press
OK
to select it.
Note
You must enter the exact uppercase (capital) and lowercase
(small) letters. Otherwise, the wireless connection will fail.
If a message says you entered an invalid WPA or WEP key, check the key
you wrote down for your new network, and then re-enter the key.
b.
When you are finished entering the WPA or WEP key, use the arrow buttons
to highlight
Done
on the visual keyboard.
c.
Press
OK
to confirm.
The HP All-in-One will attempt to connect to the network. If the connection
fails, follow the prompts to correct the key, and then try again. See also,
.
7.
When the HP All-in-One connects successfully to the network, go to your
computer to install the software on each computer that will use the network. See
Install the software for a network connection
To connect the HP All-in-One with Secure EzSetup
1.
Activate Secure EzSetup on your access point.
2.
On the control panel of your HP All-in-One, press the
Setup
button.
3.
Press until
Network
is highlighted, then press
OK
.
Chapter 4
62
HP Photosmart 3300 All-in-One series
Netw
ork
setup