HP Photosmart 3310 All-in-One Printer - Manual (Page 57)

telephone wall jack and plug it into the port labeled "2-EXT" on the back of your
HP All-in-One.
3. Connect a phone to the "OUT" port on the back of your computer modem.
4. Using the phone cord supplied in the box with your HP All-in-One, connect one
end to your telephone wall jack, then connect the other end to the port labeled "1-
LINE" on the back of your HP All-in-One.
Note If you do not use the supplied cord to connect from the telephone
wall jack to your HP All-in-One, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might
already have in your home or office. If the supplied phone cord is too
short, see
The phone cord that came with my HP All-in-One is not long
enough for information on extending it.
5. If your computer modem software is set to receive faxes to your computer
automatically, turn off that setting.
Note If you do not turn off the automatic fax reception setting in your
modem software, your HP All-in-One will not be able to receive faxes.
6. Set the Auto Answer setting to Off .
For information on changing this setting, see Set the answer mode .
7. Run a fax test. For information, see Test your fax setup .
You must be available to respond in person to incoming fax calls, or your HP All-in-
One cannot receive faxes. For information on receiving faxes manually, see
Receive a
fax manually .
Change settings on the HP All-in-One to receive faxes
In order to receive faxes successfully, you need to change some settings on your
HP All-in-One.
Note The HP All-in-One is usually set up to receive faxes during the
HP Image Zone software installation through the Fax Setup Wizard (Windows
users) or Fax Setup Utility (Mac users). Depending on the information you
provided, the HP All-in-One will be set to receive faxes automatically or
manually. You can change the setting at any time from the control panel.
If you are unsure which settings to choose for the options described in this section,
see
Set up the HP All-in-One for faxing .
Set the answer mode
The answer mode determines whether your HP All-in-One answers incoming calls or
not.
●
If you set the HP All-in-One to answer faxes automatically, the HP All-in-One will
answer all incoming calls and receive faxes. Set the
Auto Answer setting to On .
● If you set the HP All-in-One to answer faxes manually, you must be available to
respond in person to the incoming fax call or your HP All-in-One will not receive
faxes. Set the
Auto Answer setting to Off . For more information on receiving
faxes manually, see Receive a fax manually .
Chapter 3
54 HP Photosmart 3300 All-in-One series
Finish
setup