HP Photosmart 3310 All-in-One Printer - Manual (Page 72)

To set up your HP All-in-One on a wired network, you need to do the following:
●
First, collect all of the required materials, as explained in the next section, What
you need for a wired network .
● Next, connect your HP All-in-One to the router, switch, or wireless access point.
See
Connect your HP All-in-One to the network .
● Finally, install the software, as explained in Install the software for a network
connection .
What you need for a wired network
❑ A functional Ethernet network that includes an Ethernet router, switch, or a
wireless access point with Ethernet ports.
❑ CAT-5 Ethernet cable.
Although standard Ethernet cables look similar to standard telephone cables,
they are not interchangeable. There is a different number of wires in each one,
and each has a different connector. An Ethernet cable connector (also called an
RJ-45 connector) is wider and thicker and always has 8 contacts on the end. A
phone connector has between 2 and 6 contacts.
❑ A desktop computer or laptop with either a wired or wireless connection to the
router or access point.
Note The HP All-in-One supports both 10 Mbps and 100 Mbps Ethernet
networks. If you are purchasing, or have purchased, a network interface
card (NIC), make sure it can operate at either speed.
❑ HP recommends Broadband Internet access such as cable or DSL. Broadband
Internet access is required if you want to access HP Instant Share directly from
the device. For more information on HP Instant Share, see
Share your images
with family and friends .
User Guide 69
Network setup