HP Photosmart 3310 All-in-One Printer - Manual (Page 189)

Note This information does not apply to customers in Japan. For information on service
options in Japan, see HP Quick Exchange Service (Japan) and the instructions
described in Pack your HP All-in-One .
Caution The HP All-in-One must be unplugged before following these steps.
1. Remove the control panel faceplate as follows:
a.
Rotate the control panel up as far as it will go.
b. Using both hands, place your index fingers on the notches on each side of the control
panel.
c. Gently pull the faceplate towards you to remove it from the device.
2. Retain the control panel faceplate. Do not return the control panel faceplate with the HP All-
in-One.
Caution The replacement HP All-in-One might not come with a control panel
faceplate. Store your control panel faceplate (along with the power cord) in a safe
place, and when the replacement HP All-in-One arrives, reattach your control panel
faceplate. You must attach your control panel faceplate to use the control panel
functions on the replacement HP All-in-One.
Note See the Setup Guide that came with your HP All-in-One for instructions on
how to attach your control panel faceplate. The replacement HP All-in-One might
come with instructions for setting up your device.
Chapter 15
186 HP Photosmart 3300 All-in-One series
HP w
arranty
and
support