Bondioli&Pavesi 399USA011_D - Manual (Page 18)

18
ENG
Clean and grease the tractor PTO and implement input connection shaft to
facilitate installation of the driveline.
Keep the driveline horizontal during handling to prevent the halves from sli-
ding apart, which could cause injury or damage the shielding. Use suitable
means to transport heavy drivelines.
PUSH - PIN
Push the pin and slide the yoke onto the PTO shaft so that the pin engages
the groove on the PTO. Make sure that the pin returns to its initial position after
attachment to the shaft.
BALL COLLAR
Align the yoke on the PTO. Push or pull the collar to the open position. Slide
the yoke onto the splined shaft. Release the collar and pull or push the yoke along
the shaft until the balls engage the groove and the collar returns to its original
(closed) position. Make sure the collar returns to its initial (closed) position and the
yoke is properly attached to the shaft.
AUTOMATIC BALL COLLAR
Pull the collar back until it locks in the open position. Use both hands to slide
the yoke onto the shaft - the collar will automatically unlock. Push or pull the yoke
along the shaft until the balls engage the groove and the collar returns to its original
(closed) position. Make sure the collar returns to its initial (closed) position and the
yoke is properly attached to the shaft.
TAPER PIN
Ensure correct tightening of the nut before use.
Slide the yoke onto the PTO and insert the pin so that the tapered profile fits into
the groove on the shaft. Recommended tightening torque:
150 Nm (110 ft lbs) for 1 3/8” Z6 or Z21 profiles.
220 Nm (160 ft lbs) for 1 3/4” Z6 or Z20 profiles.
Use only Bondioli & Pavesi taper pins for replacement.
CLAMP BOLT
Ensure correct tightening of the bolt before use.
Recommended tightening torque:
91 Nm (67 ft lbs) for M12 bolts. 144 Nm (106 ft lbs) for M14 bolts.
LUBRICATION
Always wear adequate safety equipment when performing any maintenance
or repair work.
LUBRICATION OF TELESCOPING TUBES
If grease fittings are not provided, separate the two halves of the driveline,
and manually lubricate the telescoping tubes.
GREASING SYSTEM
If the driveline is equipped with the Greasing System the telescoping tubes
may be lubricated via the grease fitting located next to the tube yoke.
The Greasing System enables rapid lubrication of telescoping tubes at any driveli-
ne position, without removal from either the tractor or implement.
26
27
28
29
30
31
32
33
34
35