Bondioli&Pavesi 399USA011_D User Manual

Page 22

Advertising
background image

22

ENG

Remove the CV cone.

Disengage the retaining spring, leaving it inserted in one of the two holes of

the bearing ring to avoid losing it.

Spread the bearing rings and remove from their groove.

CV JOINT SHIELD ASSEMBLY

Grease the bearing grooves.

Fit the bearing ring into the yoke groove with the grease fitting facing the

drive tube.

Install the bearing ring on the CV body with the reference pins facing the

inner yoke. The bearing ring is equipped with a grease fitting, used only for

50° CV joints. This grease fitting is not used with 80° CV joints.

Connect the retaining spring to the two edges of the bearing ring.

Slide the CV cone onto the CV body and align the radial holes with the be-

aring ring reference pins. Align the hole at the base of the CV cone with the

grease fitting on the smaller bearing ring.

In the case of 50° CV joints only: insert the shield strip, aligning with the

elements specified in point 66, and also the additional hole of the shield strip

with the grease fitting of the large ring.

Ensure that the radial holes of the CV cone are aligned with the holes on the

reference pins of the bearing ring.

In the case of 50° CV joints only: Ensure that the radial holes of the shield

strip are aligned with the holes on the reference pins of the bearing ring

and that the access hole on the CV cone is aligned with the grease fitting of the

bearing ring.

Tighten the 6 flange head screws of the protection strip. The use of an elec-

tric screwdriver is not recommended.

Fit the base cone and tube, inserting the grease fitting in the hole on the

base cone.

Tighten the 3 screws. Use of electric powered screwdrivers is not recommended.

SHORTENING THE DRIVELINE

Bondioli & Pavesi does not recommend modifications to its products.

If the driveline needs to be shortened, proceed as described below.

If you are unsure of the procedure, or need additional assistance, please contact

your local implement dealer or qualified service center.

Remove shielding.

61
62
63

64

65

66
67

68

69

70

71

72

73

74

75

Advertising