Festo Электроцилиндр ESBF - Manual (Page 16)

ESBF-BS
16 Festo – ESBF-BS – 1201NH English
• Please select the appropriate motors from our catalogue ( www.festo.com/catalogue).
Using an appropriate Festo motor will ensure that the components are fully compatible with one
another.
When using other motors:
• Do not exceed the limit values for forces and speeds
( 12 Technical data and 13 Characteristic curves in the Appendix).
3 Transport and storage
• Consider the weight of the electric cylinder.
Depending on the version, the ESBF can weigh up to 35 kg.
• Make sure storage conditions are as follows:
– Storage times should be kept to a minimum
– Store in cool, dry, well-shaded corrosion-resistant storage areas.
4 Prerequisites for use
Warning
Unexpectedly fast-moving masses can harm people or property (risk of crushing).
• Before commissioning, limit the drive motor to low speeds and torques to start with.
Note
Malfunctions will occur if the device is incorrectly used.
• Make sure that the specifications contained in this chapter are adhered to at all
times.
• Take into consideration the legal regulations applicable for the destination, as well as:
– regulations and standards,
– regulations of the testing organizations and insurers,
– national specifications.
• Note the warnings and instructions on the product and in the relevant operating instructions.
• Remove all transport packaging such as foils, caps and cartons
(except for any plugs).
The material used in the packaging is intended for recycling
(exception: oil paper = residual waste).
• Use the product in its original state, without any unauthorised product modifications.
• Take into consideration the ambient conditions at the location of use.
Corrosive environments reduce the service life of the product (e.g. ozone).