Cirrus Logic CS4970x4 - Manual (Page 114)

8-4 Copyright 2013 Cirrus Logic, Inc. DS810UM6
Elements of a Project
CS4953x4/CS4970x4 System Designer’s Guide
8.3 Elements of a Project
The contents of a project are represented in the DSP Condenser Wizard GUI using “Master–Details”
arrangement. This arangement consists of a tree of project elements (Master) on the left side of the GUI
window and a set of properties (Details), displayed on the right, which vary according to the selection in
the master. Refer to the following screenshots of DSP Condenser sections for detailed descriptions of a
project’s content.
8.3.1 General Page
The General page is used to define common project settings.
Figure 8-2. DSP Condenser Wizard, General Page
Target DSP type — Displays the target DSP chip type for the current project (read only).
Target flash type — Selects the type of serial flash used in current project.
Project version — The 20-character version number of flash image. This number should be incremented
when new versions are released. The project version string will be programmed into the flash image and
can then be accessed by the MCU using the DSP Manager API.
Manufacturer — The 20-character manufacturer's ID (optional).
Product ID — The project's unique, 32-bit product ID (optional).
Region ID — The 16-bit region ID (optional).
Memory maps — List of supported firmware versions (read only).
DSP scratchpad start — Beginning address of the flash area used by the DSP to save runtime settings.
MCU scratchpad start — Beginning address of the flash area used by the MCU to save runtime settings.